Is This Safe?

Kinja'd!!! "Rev Hang Slows My Roll" (RevHang)
04/29/2014 at 20:25 • Filed to: None

Kinja'd!!!0 Kinja'd!!! 8

I plugged a non essential coolant channel with a bolt and a healthy dab of permatex 1. Is this going to hold or will it explode all over the engine bay or at least leak a bit?


DISCUSSION (8)


Kinja'd!!! aberson Bresident of the FullyAssed Committe > Rev Hang Slows My Roll
04/29/2014 at 20:30

Kinja'd!!!0

as long as the permatex sets up properly it should be good for a few short trips

but its not a permanent solution

you can also un-screw your radiator cap a bit to relive some pressure on the system just make sure to keep a eye on the water temp though


Kinja'd!!! Aaron James > Rev Hang Slows My Roll
04/29/2014 at 20:40

Kinja'd!!!0

Put a hose clamp on there and you'll be all set. Otherwise it will eventually fail in a most likely spectacular fashion.


Kinja'd!!! deekster_caddy > Rev Hang Slows My Roll
04/29/2014 at 20:42

Kinja'd!!!1

Need more information. Was it a threaded hole? Or did you just jam a bolt into a hose? Or what?

If it was a bolt hole, i.e. straight threads, some RTV should hold for a while. If it was pipe threads (reducing in diameter) you are good to go. If there were no threads and you just jammed a bolt into a tight fitting hole with some RTV, I wouldn't trust it very far.


Kinja'd!!! Arben72 > Rev Hang Slows My Roll
04/29/2014 at 21:00

Kinja'd!!!0

Put a hose clamp on it and you'll be good.


Kinja'd!!! crowmolly > deekster_caddy
04/29/2014 at 21:09

Kinja'd!!!0

Yeah, we need more info. If it's threaded there's a pretty good chance you will be OK.


Kinja'd!!! Rev Hang Slows My Roll > deekster_caddy
04/29/2014 at 21:56

Kinja'd!!!0

no threads. i just but in the closest fitting bolt i had and slathered it with permatex 1. the pressurized system runs about 16psi i think.


Kinja'd!!! desertdog5051 > Rev Hang Slows My Roll
04/29/2014 at 22:01

Kinja'd!!!1

If it is a hose, put a clamp on it. If is not clampable, better carry some extra coolant with you.


Kinja'd!!! Stef Schrader > desertdog5051
04/30/2014 at 01:00

Kinja'd!!!1

Yep. Clamp that sucker, and make sure it's not dangling anywhere important. If the bolt's a tight fit, this should be sufficient—even without the Permatex.